I/O (Right Connector) - Peak PCAN-MicroMod FD User Manual

Pin Identifier Function
3 CAN_L
High-speed CAN connection (ISO 11898-2)
4 CAN_H
5 Fout_0
Frequency outputs (up to 10 kHz)
6 Fout_1
Start the CAN bootloader for a firmware
update via CAN
7 Boot
(High-active, connection to Ub during the
start-up of the motherboard)
8 AIn12_7 Analog input 7 (0 - 30 V, resolution 12 bits)
9 UART_Rx
Serial RS-232 interface
10 UART_Tx
For the startup of the PCAN-MicroMod FD Analog 1 it is sufficient to connect a voltage
source to pins 1 and 2. The configuration of the PCAN-MicroMod FD Analog 1 is done
via the CAN bus being connected to pins 3 and 4. Read more in 5 Configuration Soft-
ware on page 15.

2.2 I/O (right connector)

Function
Ground
Digital inputs
2 Connectors PCAN-MicroMod FD Analog 1
User Manual 1.2.0 © 2021 PEAK-System Technik GmbH
Right connector 2 x 11 terminals
A Pin
GND 11
DIn_1 10
DIn_0 9
Comment
Internal termination resistor 120 Ω can
be activated.
See 4.2 Activate Internal CAN Bus Termin-
ation on page 13.
Activity LED quickly blinks orange when
CAN bootloader is active
General tasks, e.g. voltage monitoring
or threshold switch
Corrently no use
B
5-Volt supply for external devices
5Vout
DIn_3
DIn_2
Function
(max. 100 mA)
Digital inputs
8