6 Firmware Update
The PCAN-MicroMod FD Analog 1 (called MicroMod FD device in this chapter) can
receive a firmware update via CAN. This is done with the Windows program PEAK-
Flash.
Go through the following sections for a firmware update.
6.1 System Requirements Firmware Update
Windows 10, 8.1 (32/64-Bit)
PC-CAN interface from PEAK-System (CAN FD capability recommended)
CAN cabling between the CAN interface and the PCAN-MicroMod FD Analog 1 with
proper termination (120 Ω on each end of the CAN bus)
6.2 Flash Software Preparation
With the PEAK-Flash software for Windows, it is possible to update the firmware of
our hardware products. This is done via a CAN connection. The software package is
freely available on our website.
Do the following to setup PEAK-Flash:
1. Download the software package for PEAK-Flash from our Website. Go to the
corresponding entry on the following download page:
www.peak-system.com/quick/DL-Software-E
6 Firmware Update
PCAN-MicroMod FD Analog 1
User Manual 1.2.0
© 2021 PEAK-System Technik GmbH
17