Update Procedure - Peak PCAN-MicroMod FD User Manual

2. Unpack the downloaded PEAK-Flash.zip file to an arbitrary target
directory on your Windows computer.
The PEAK-Flash.exe file in the target directory is the executable to be
used later.
3. [Optional] On the Windows desktop, create a link to PEAK-Flash.exe for
easier access to the program later.

6.3 Update Procedure

Do the following to start the firmware update:
1. Power up the MicroMod FD device.
2. On Windows, start PEAK-Flash.exe.
Panel 1 of PEAK-Flash with general information is shown.
3. Click on Next.
Panel 2 Select Hardware of PEAK-Flash is shown.
4. Select Modules connected to the CAN bus.
5. From the list Channels of connected CAN hardware, select the CAN interface
that establishes the connection to the CAN bus.
6. From the Bit rate list, select 500 kbit/s (usually pre-selected).
7. Click on Detect.
After a few seconds, a new entry with the name of the MicroMod FD device is
shown in the field below, including the current module ID and firmware
version.
8. Click on Next.
Panel 3 Select Firmware of PEAK-Flash is shown.
6 Firmware Update PCAN-MicroMod FD Analog 1
User Manual 1.2.0 © 2021 PEAK-System Technik GmbH
18