Camera Setting - Ganz DIGIMASTER DR-16M55-RA-4TB User Manual

Camera Setting

You can configure the display settings of: camera title, hidden option, motion and camera type.
Camera Type Setup
\ \
This is used to set up the type of signal for each camera channel.
From <SYSTEM SETUP> - <CAMERA>, select
1.
<Camera Type Setup>.
/ENTER] buttons on the remote
Use the [
2.
$ %_+
controller or the mouse to set the type appropriate
for the camera connected.
Not all types are compatible therefore check before

connecting the camera.
To apply the change, click <APPLY> in the bottom of
3.
the screen.
When done, press the [EXIT] button on the remote
4.
control or click <CLOSE> in the lower screen. The
confirmation message appears and you will return to
the previous menu.
TVI, AHD are all for analogue cameras, and IPCAM is for network cameras.

If the type of IPCAM signal is selected or deselected, the configured signal type will be applied after restarting the system.

IPcamera Installation
Cameras connected to the network will be added
1.
through <AUTO SCAN>, and can also be added
manually by entering an access address with
<SPECIFIC IP / HOST NAME>.
In addition, it is possible to use it like a camera input
by receiving RTSP streaming from equipment which
provides a streaming service.
The added IP camera can be allocated to the desired
2.
channel. (This applies only to the channel designated
as IPCAM from the camera type set-up page.)
Assign a channel number to the camera searched,
3.
and press < > to add the camera.
When done, press the [EXIT] button on the remote control or click <CLOSE> in the lower screen to return to the
4.
previous menu.
Recording may be stopped during additional camera work.

The HTTP/RTSP port forwarding should be set same as the port of the camera when connecting the camera through the router from
J
an external network.
35
|
English