Connecting To An External Device - Ganz DIGIMASTER DR-16M55-RA-4TB User Manual

Installation

Connecting to an external device

Connecting to the monitor
\ \
This product supports 1080p 60 Hz HDMI monitors and regular monitors that support DVI and VGA inputs. Use the
switch on the product s rear side to set it for HDMI or VGA monitor. Connect an HDMI cable to the port on the product
'
s rear bottom, or connect an HDMI-DVI converter cable to connect a DVI monitor. Or, use VGA cable to connect the
product with a VGA monitor.
Once the product is set for NTSC or PAL output, connect cameras of the corresponding video standard for
~
proper operations.
J
Power Connection
\ \
Connect the power cable supplied with the product into the power socket on the main unit
1
2
1
2
J
J
J
J
J
J
16
|
Installation
Make sure to connect the product to a monitor that supports 1920x1080 at 60Hz.
(HDMI, DVI, VGA)
AUDIO IN
3 5 7 9 11 13 15
AUDIO
OUT
4 6 8 10 12 14 16
3 5 7 9 11 13 15
4 6 8 10 12 14 16
VIDEO IN
For stable operation of the product, it is recommended to use the adapter provided. (12V, 10A)
Make connection when the power is not applied yet.
Arrange up the cables and be careful not to peel off the cable coating.
Do not place the power cord under the carpet or rug. The power cord is usually earth-grounded. However, even if
it's not earth-grounded, do never modify it on your own for earth-grounding.
Do not insert multiple devices in a single power socket. Otherwise, it may cause a power overload.
For stable power supply, this product provides two separate adaptors and two corresponding AC cords by factory
default. Make sure all cables are connected properly.
SPOT
OUT
WAN(UPLINK)
VGA
HD
e-SATA USB LAN(DOWNLINK)
MONITOR
Power adaptor
s rear side.
'
DC12V
DC12V
'