Maintenance; Replacing An Io Module - Promise Technology VTrak J5960 Series Product Manual

Promise Technology

Maintenance

VTrak J5960 uses a modular design with placement of the various modules intended to make hardware module
replacement easy to accomplish with the enclosure remaining in the rack. With the exception of the carrier disks,
hardware module replacement can be accomplished without even sliding the device out from the rack. PSU, Fan
and IO Modules are accessible from the front and back. Disk carriers require that the top be slid to expose the
interior, which in most cases will require that the enclosure to slide out from the rack. In no circumstance will it be
necessary to remove the enclosure from the sliding rail system. The Fan and PSU modules are situated above
the Cable Management Arm, so these are easily accessible without adjusting the CMA.
As with all replacement components, please contact your PROMISE reseller for information on how to purchase
replacement parts.

Replacing an IO Module

IO Modules are hot swappable. You will need access to the front of the VTrak J5960 to replace an IO module.
IO Modules on front of device
To remove the IO Module, lift the lever up to unseat the module and pull it toward you. It should slide out
easily.
33
Hardware Setup