Promise Technology VTrak J5960 Series Product Manual page 77

Promise Technology System Management
7. Reset to the factory default settings and restart a dual IOM again.
factorydefaults
enclosure -m -r 2
The following example is a message after restarting a
dual IOM:
cli> factorydefaults
Please reboot the system for the change to take effect.
cli> enclosure -m -r 2
Rebooting the system
Send SES page to level-2 expander OK!
Send SES page to level-3 expander OK!NVSRM installed
dsk_cnt = 60, board
Performing POST for Smart Serial
Boot Cause: Internal Register Reset
System Internal Register Reset on
************************************************
Promise 4U-SAS-60-D BP v1.00.0000.13
************************************************
cli>
67