Configuration Procedure; Table 3-1 Configuration Procedure - Honeywell UDC3300 User Manual

3.2 Configuration Procedure

Each of the Set Up groups and their functions are pre-configured at the factory. The
factory settings are shown in Table 3-2 through Table 3-13. Follow the procedure in
Table 3-1 if you want to make changes to any of these selections or values. Record
your selections on the Configuration Record Sheet found in Appendix C.
Step Operation
1 Select Set Up
mode
Select any Set
2
Up group
3 Select a Function
parameter
Change the value
4
or selection
Enter the value
5
or selection
Exit
6
Configuration
5/00

Table 3-1 Configuration Procedure

Press
SET UP Upper Display: SET UP
Lower Display: TUNING (This is the first Set Up
group title.)
Sequentially displays the other Set Up group titles.
SET UP
You can also use the [ ] [ ] keys to scan the Set
Up groups in both directions. Stop at the Set Up
group title that describes the group of parameters
you want to configure. Then proceed to the next
step.
FUNCTION Upper Display: Shows the current value or
selection for the first Function prompt of the
selected Set Up group.
Lower Display: Shows the first Function prompt
within that Set Up group.
Sequentially displays the other function prompts of
the selected Set Up group. Stop at the function
prompt that you want to change, then proceed to
the next step.
Increments or decrements the value or selection
or
that appears for the selected function.
If the display flashes, you are trying to make an
unacceptable entry.
This key selects another Function prompt.
FUNCTION
or
This key selects another Set Up group.
SET UP
The value or selection you have made will be
entered into memory after another key is pressed.
Exits configuration mode and returns the controller
LOWER
to the same state it was in immediately preceding
DISPLAY
entry into the Set Up mode. It stores any changes
you have made.
UDC3300 Basic Model: DC330B User Manual
Configuration
Result
21