Nec Electra Pro I - NEC NVM-CA Series Integration Manual

NEC Electra Pro I

Integration Notes
Required Hardware and Software
3
3
3
Voice Mail Availability
Phone System Programming
FIRST: About the Voice Mail Extensions
You must connect each the Voice Mail port that you want to use to an extension (Keyset) port in the
Electra telephone system. The extension numbers assigned to the selected ports must be in the
same 10's group. For example, all the Voice Mail extension numbers must be in the range 10-19, or
20-29, or 30-39, etc. Make a note of the selected port and extension numbers, because you will
need them for programming. The default port-to-extension assignments are shown in Electra LK4
programming, Data No. 06. You can also use that Data No. to change the port-to-extension assign-
ments, if necessary.
LK1 System Mode Programming
Issue 1-0
One push-button receiver card: PBR-C (4N)-11KTU
Each Voice Mail port must be connected to a SLT-F(1G)-10ADP,
which in turn must be connected to a port on ESI-C (8)-11: a regular electronics card.
Any software level is OK.
This phone system is available on the NVM-2000CA with Software Version 8.01 or higher.
Data No. 67 - Voice Mail Access Code Assignment
3
01 Remote Logon (Internal)
Enter ***1.
3
02 Direct Logon
Enter ***1.
3
03 Transfer Message
Enter ***2.
3
04 Record Message
Enter ***2.
3
05 Forward All Calls
Enter ***3.
3
06 Forward Busy
Enter ***4.
3
07 Forward No Answer
Enter ***5.
3
08 Remote Logon (Trunk)
Enter ***6.
3
09 DTMF Disconnect Signal
Enter 9999.
3
10 Message Wait Indication (set)
Enter *4.
3
11 Message Wait Indication (cancel)
Enter *5.
Integration Notes
NEC Electra Pro I
X
143