NEC NVM-CA Series Integration Manual page 111

Phone System Programming (cont'd)
Extension Programming
When you are going to program the Voice Mail system through an extension in the telephone
system, use the programs in the order listed below:
System Options
Listed below are two types of Voice Mail options:
3
3
Issue 1-0
Program 14
Assign Circuit Type 51 to each VX port.
Program 18 (l)
Assign the Voice Mail feature to each VX port selected in Program 14.
Program 3
Indicate that the Voice Mail is installed and select a VX Master Extension Number.
This number can be any of the VX ports designated in Program 14.
Program 19
Set up a UCD Hunt Group as follows:
- Hunt Type = 05
- Master Extension = VX Master Extension Number assigned in Program 3
- Overflow extension = Operator extension that you assigned to the VX Master Extension
Number in Program 18 (l)
- UCD Members - VX extensions that you selected in Program 18 (l)
Program 12
Directly terminate each line that the Automated Attendant should answer to the VX Master
Extension Number you selected in Program 3.
Program 17
Assign a Record key to an extension, if required.
Program 16
Assign each VX port (selected in Program 14) outgoing access to the lines used for Message
Notification.
Ones that the ONYX VS does not use (listed as "not used")
Ones that may have default values not listed in the Programming Guide
RNA, Hold Retrieval String
Not used
Busy, Hold Retrieval String
Not used
Lamp On String
#XG
DEFAULT:
Lamp Off String
#X00
DEFAULT:
Integration Notes
ONYX VS
X
107