NEC NVM-CA Series Integration Manual page 50

Lucent ACS
Phone System Programming (cont'd)
If you are going to set up unscreened Automated Attendant transfers
(UTRF) to the extensions:
If you are going to set up screened Automated Attendant transfers
(TRFs) to the extensions:
:
46
Program 310 Auto VMS Cover
Use this program to determine whether an extension's unanswered intercom and transferred
calls are automatically covered by the voice messaging system. When Do Not Disturb is acti-
vated, calls will go to voice messaging regardless of whether or not Program 310 is enabled.
Program 208 Line Coverage Extension
Use this program to identify an extension as the owner of a specific outside line. This allows
the extension to activate call coverage for the line. (Do Not Disturb overrides this feature and
immediately routes the call to Voice Mail.)
Program 116 Call Coverage Rings
Use this program to specify the number of times a covered extension rings before a call is
routed to the covering extension. If the covering extension is programmed for Call Coverage
and VMS Cover, the call first rings the number of times specified in Program 116. After it
rings the number of times specified in VMS Cover Rings, the call is routed to Voice Mail.
Program 117 VMS Cover Rings
Use this program to determine the number of times that an extension should ring (1 to 9) ,
before the call will be routed to Voice Mail. Either VMS Cover (feature 15) or Automatic VMS
Cover (Program 310) must be active for the covered extension. The default number of rings is
3.
Program 306 Transfer Return Extension
Use this program to determine the destination of an incomplete Auto Attendant transfer. The
destination is typically extension 10. An incomplete transfer is one that is not answered or one
that does not have Voice Mail coverage.
Program 105 Transfer Return Rings
Use this program to set this timer higher than Rings before redirect transfer for any Call
Routing Mailbox that is handling calls.
Integration Notes Issue 1-0