NEC NVM-CA Series Integration Manual page 253

Toshiba Strata DK8/16
Integration Notes
Required Hardware and Software
Voice Mail Availability
Phone System Programming
Issue 1-0
3
One single line port per Voice Mail port
3
One PSTU (Analog) Card
3
One CRCU-4 (DTMF) Card
This phone system is available on the NVM-2CA Voice Mail system.
Program 10-1 - System Assignments
Ring Transfer, LED 07 - Enable (LED on)
Program 10-2 - System Assignments
•
DTMF Tone Return, LED II - Enable (LED off)
•
Voice Mail ID Code, DTMF Signal Time, LED 06 - Set for 80ms (LED on)
•
Voice Mail MW Cancel via Dial #64/Automatic, LED 04 - Enable (LED on).
Program 12 - System Assignments / Basic Timing
Flash Timing, Code 4 - Set @ 0.5 seconds
Program 13 - Defining the Message Center
Assign the lowest-numbered Voice Mail port to Message Center.
Program 15 - Assigning DP/DTMF
Auto-Release (AR) on VM calls, Code 0 - Enable for all CO lines
Program 31 - Station Class of Service
For VM Ports:
•
Toshiba VP (B + Sta #), LED 20 - Enable
•
Toshiba VP (B, No Sta), LED 19 - Enable
•
End/End Signal RCV (VM), LED 17 - Must enable
•
Receive VM ID Code, LED 16 - Enable
•
Toshiba VP Integration (A Tone/D), LED 15 - Enable
•
VM No Conference, LED 09 - Enable (LED on)
•
VM Groups 1 - 4, LED 05-08 - Put all VM ports into group 1, LED 05 (LED 05 on)
•
VM to VM Call blocking, LED 04 - Enable (LED on)
•
Executive and Privacy Override Blocking, LED 18 - Enable (LED on)
Program 33 - Station Hunting
Each Voice Mail port must be set up as a member of a hunt group.
Integration Notes
Toshiba Strata DK8/16
:
249