NEC NVM-CA Series Integration Manual page 172

COMDIAL Impact
Phone System Programming (cont'd)
X
168
Dial 16 - Tone First Intercom Signaling
This must be set to Tone First.
Dial 54, 2 - Delay Ring Line/Station Assignment
Enter each line and Voice Mail port that should be answered on a delayed-ring basis.
Dial 54, 3 - Night Ring (Transfer) Line/Station Assignments
When the phone system is placed in Night Mode, enter each line and Voice Mail port that
should be answered.
Dial 53, 18 - Intercom Hunt Group
Program all Voice Mail (ATI-D) ports into a Circular Hunt Group.
Dial 53, 06 - Message Wait Originate
Enable this feature for each Voice Mail ATI-D that will perform Message Waiting callouts. It
is recommended that you use only one port for callouts. By default, the Voice Mail sends Mes-
sage Waiting callouts on the highest numbered installed Voice Mail port.
Dial 53, 09 - Ringing Line Preference
Enable Ringing Line Preference for each Voice Mail ATI-D.
Dial 06 - Station Names
Assign a name to each Voice Mail ATI-D extension (typically, "Voice Mail 1," "Voice Mail 2,"
etc.).
Dial 53, 07 - ATI thru dialing
Enable this feature for each Voice Mail ATI-D.
Dial 53, 32 - Assign Voice Mail Ports
Enable this feature for each Voice Mail ATI-D.
Dial 54, 1 - Assign Direct Ringing for Automatic Attendant
Operation
Assign any line that should be answered by the Automated Attendant to each ATI-D extension.
Dial 25 - Automatic Transfer of Voice Mail
Use this program only if the Automated Attendant is set up for unscreened transfers. Do NOT
enable this feature if the Automated Attendant is set up for screened transfers.
Dial 43 - Voice Mail line ID
Use this program to assign a Trunk Mailbox to an incoming line: Enter 0# and a suffix. The
suffix represents the line number and MUST have the same number of digits as in a typical
extension number. By default, the suffix that the Voice Mail creates for line 1 is 071, for line 2
is 072, etc.
Dial 29 - Feature Inhibit Programming
If you are having trouble getting a particular feature to work, make sure that you have not inad-
vertently disabled the feature in the Feature Inhibit Programming.
Integration Notes Issue 1-0