Connections; Power - Agilent Technologies AA Series User Manual

Getting Started

Connections

Your Agilent AA instrument is supplied with a set of gas hose fittings
and a mains cable which suits the common utility standard in the
local region. A Country Kit must be ordered with the Agilent AA
instrument.

Power

The mains power connection is located at the rear of the instrument.
Refer to the next section for instructions on connecting the
instrument to the mains power supply.
Gas Hoses
Three rubber hoses are permanently attached to the instrument.
Each hose is 1.8 meters long and is color-coded for air (black),
nitrous oxide (blue) and acetylene (red). Each is fitted with female
fittings suitable for USA standard regulators. Adaptors are supplied
for other areas.
Gas hose connections are not detailed in this section as they are described in
NOTE
your Agilent AA Site Preparation Guide.
Accessories
For details on connecting accessories such as SIPS or UltrAA lamps,
refer to the manuals accompanying the accessories.
Power
Requirements
Power requirements are detailed in your Agilent AA Site Preparation
Guide, and also in the Specifications section in Chapter 1 of this
manual. You should check the power requirements and read through
the section 'Electrical power supplies' in the Site Preparation Guide
before connecting the Agilent AA system to the power supply.
Consult the manuals supplied with your printer and PC (if required)
for their power requirements.
72 Agilent 240/280 Series AA User's Guide