Moving Your Instrument; Starting The System - Agilent Technologies AA Series User Manual

Getting Started
Connection
Before connecting the instrument to the power supply, ensure that
both the spectrometer and the mains power supply are turned off.
Check that the two voltage selector switches on the instrument rear
panel (if present) are set to the correct mains power supply voltage—
refer to the table on the rear panel. The voltage selectors are set by
the Agilent field service engineer when the instrument is first
installed.
To connect the instrument to the power supply, plug the mains
power cord into the back of the instrument and the free end of the
power cord into the mains power supply, and then switch the mains
power supply on.

Moving Your Instrument

WARNING Heavy Weight
The instrument weighs over 50 kg (110 lb). Do not attempt to lift the
instrument alone. Always use two or more people when lifting or carrying the
instrument into position.

Starting the System

The instrument power switch is a rocker type, located on the front of
the instrument on the left hand side. Switch this to 'I' to start the
system. The green indicator light should come on.
For instructions on how to start any accessories, refer to the manuals
supplied with the accessories.
If you have not already done so, start the SpectrAA software as
described on Page 62.
Agilent 240/280 Series AA User's Guide 73