Agilent Technologies AA Series User Manual page 44

Installation
12 Click OK.
13 Once the installation is complete, click Finish.
14 A message may appear prompting you to install the QuickCam
15 Click OK to install the SpectrAA Help.
16 Remove the SpectrAA Base CD and then insert the SpectrAA
17 Click Yes to start the SpectrAA Help and Videos installation.
18 Click Finish when the installation is complete.
19 Do one of the following:


44
b
If you select Agilent SPS 3 flame autosampler, click Edit
COM port parameters to define the COM port and the
settings to be used for communicating with the autosampler.
Refer to the SPS 3 operation manual for details of the
required communications parameters.
c
If you are installing the ETC 60 and want to control this
accessory from the SpectrAA software, select the COM Port
from the drop-down menu to be used to control this
accessory.
drivers. Click OK to dismiss the message. You must install the
SpectrAA PRO and/or the GPIB Communications device first.
The QuickCam drivers are installed later in this procedure.
Help CD. The installation program should start automatically. If
the program does not auto start, do the following:
a
From the Windows Start menu, select All Programs >
Accessories > Run. The Run dialog displays.
b
In the Run dialog, type X:\AAHelp\setup.exe (where X
represents the letter of your CD-ROM drive) and select OK to
start the installation.
c
Click Yes on the User Account Control window to run the
program.
If you are installing SpectrAA PRO, proceed to the next section
'Installing the SpectrAA PRO Software', or
Reboot your PC and then install the PCI-GPIB Communications
Card (see Page 51) or the USB-GPIB-HS Converter (see Page 55).
Agilent 240/280 Series AA User's Guide