Table of Contents
Advertisement
Fig. 12.23
Restraint chain
Rigid pipe of the appliance
Fig. 12.24
Fig. 12.25
Stability bracket
Anti-Tip bracket
0
1
/
" (3 mm) min
8
ArtNo.070-0014 - Stability bracket - Wall fitting
Fig. 12.26
Check the appliance is electrically safe when you have finished.
Alternative positions
for anti-tip device
Range
Cooker
3 mm min
Typical oor mounting
INSTALLATION
Fitting the restraint chain and anti-
tip device
1.
A range using a flexible gas connector must be secured
with a suitable restraint chain and anti-tip device.
2.
When fitting the restraint chain it should be kept as
short as is practicable and fixed firmly to the rigid pipe
at the top, right-hand, rear of the range, when viewed
from the front (Fig. 12.23).
DO NOT fix the chain to the flexible hose at the base
of the range.
3.
A suitable anti-tip device is supplied and shown in
Fig. 12.24.
4.
When fitting the anti-tip bracket (Fig. 12.24 and
Fig. 12.25), adjust the bracket to give the smallest
practicable clearance between the bracket and the
engagement slot in the rear of the range.
5.
Fit the bracket so that it engages as far as possible over
the chassis of the range.
DO NOT operate the range before the appliance is
in its installed position and the anti-tip devices are
engaged.
If the appliance is moved ensure that the anti-tip
devices are re-engaged and the range has been
returned to its original installed position.
DO NOT step, lean or swing on the range doors
or drawer as this could tip the range and result in
serious injury or death.
Completing the move
Floor
1.
Open the broiler door and right-hand oven door so that
you can get a good grip on the bottom of the fascia
panel as you move the range (Fig. 12.26).
2.
Position the range close to its final position.
3.
Check that the anti-tip devices are engaged before
moving the range into its final, installed position.
4.
Re-check that the appliance is level.
DO NOT use the door handles or control knobs to
manoeuver the range.
36
Advertisement
Table of Contents
