Table of Contents
Advertisement
Fig. 12.9
Fig. 12.10
Fig. 12.11
Fig. 12.12
Nylon Retaining
washer
Side panel bracket
INSTALLATION
Check the appliance is electrically safe when you have finished.
Gasket
Connect tab into
side bracket
bk
Flue Vent
Side Panel
Fitting the obscuring trims
1.
Located near the front on each side of the range there
are three screws. Loosen the top and bottom screws
(Fig. 12.9).
2.
Slide the trim onto the screws and tighten to secure.
Fitting the side panels
1.
Loosen the screw in the flue vent (Fig. 12.10).
2.
Inside the top of the side panel top are two tabs. Attach
the self adhesive gaskets to each tab and connect these
tabs into the cut-outs in the top edge of the range
(Fig. 12.11).
3.
Slide the side panel back so that the side panel bracket
in the base connects to the rear retaining washer and
the slotted tab at the top rear connects onto the screw
in the flue vent (Fig. 12.12).
4.
Check everything is firmly connected and tighten
the screw in the flue vent to secure the side panel in
position (Fig. 12.10).
NOTE: The bottom front of the side panels will be loose.
These are secured once the bottom panel (toe kick) is fitted.
NOTE: If a side panel is loose, fit one of the extra gaskets to
the inner face of the front bracket locating tabs and refit.
32
Advertisement
Table of Contents
