Replacing The Brushes - Taylor-Dunn B0-011-00 Operation, T Roubleshooting And Replacement Parts Manual

Replacing the Brushes

6. Remove the armature.
7. Remove the four cover retaining screws.
8. Remove the end cap from the motor, revealing the brush
holder and brushes.
9. Unfasten the brush holder retainer screws and remove the
brush holder.
NOTE: Be sure to remember the position of the
crossover wires.
1. Make sure the key-switch is in the "OFF" position, then remove
the key.
2. Place the forward-reverse switch in the center "OFF" position.
3. Set the park brake.
4. Place blocks under the front wheels to prevent vehicle movement.
5. Disconnect the main positive and negative cables at the batteries.
Section 3
MB-100-00
Page 39