MB-100-00
25. Remove the bearings from the input shaft.
26. Remove the O-rings from the outer input
bearing bore and both intermediate bearing
bores.
27. Inspect all parts for signs of wear or damage.
Note: Bearing, seal and gear surfaces
should be inspected for pitting,
wear, overheating or scoring.
Replace these parts as needed.
28. Reinstall or replace all parts using this
procedure in reverse order.
NOTE: Be sure to pre-lube all of the bearings with 30 weight motor oil.
29. Fill the differential with oil.
30. Adjust the brakes.
31. Lower the vehicle.
32. Reconnect the main positive and negative at the batteries.
33. Remove the blocks from behind the wheels.
34. Release the park brake and test drive the vehicle.
Input Shaft Bearing
Input Shaft
Section 3
Page 34
Input Shaft Bearing
Snap Ring
Input Shaft Assembly