MB-100-00
10. Clean all grease from the inside of the hub and bearings.
11. Inspect and replace the races and bearings as a set.
NOTE: It is recommended to replace both the left and right wheel bearings
at the same time.
12. Assemble in reverse order, using new grease seals.
a. Pack inner and outer bearings with grease.
b. While rotating the hub, tighten the spindle nut to 30 ft-lbs. to seat the bearings.
c. Back off spindle nut one flat until the hub turns, but is not loose, then install a new cotter pin.
13. Install the dust cap.
14. Reinstall the brake bodies and the tire/wheel assembly.
15. Lower the vehicle.
16. Reconnect the main positive and negative at the batteries.
17. Remove the blocks from behind the wheels.
18. Release the park brake and test drive the vehicle.
Section 3
Page 22