Taylor-Dunn B0-011-00 Operation, T Roubleshooting And Replacement Parts Manual page 55

Differential Case
Drive Gear
Differential Bearing
Bearing Cap
Differential Case Assembly
O-Ring
Snap Ring
Intermediate Shaft Assembly
22. Remove the O-rings from the intermediate shaft.
23. Remove the snap ring from the input shaft bore plug.
24. Pull the input shaft assembly from the housing.
Bore Plug
Intermediate Shaft
Intermediate Shaft Bearing
Section 3
13. Remove the bearing cap screws and bearing caps.
NOTE: Bearing caps are marked for
identification. During reassembly,
make sure they are put back in their
original position.
14. Remove the differential case assembly from the
housing.
15. Remove the differential bearings from each side of
the differential case.
16. Remove the drive gear from the differential case.
17. Punch or drill a 1/8" hole in the center of each bearing
bore plug.
18. Insert a #10 x 1.25" sheet metal screw into
the hole until the bore plug is forced out of
the bearing bore.
19. Remove the snap ring from each bearing
bore.
20. Drive the intermediate shaft from the flange
side of the housing.
21. Remove the intermediate shaft bearings
from the housing.
Page 33
MB-100-00