SL-KT880E-GR/RL/R
4-6.4.1 NorthBridge Configuration
Choose "NorthBridge Configuration" in "Advanced Chipset Features"
and press <Enter>. The following sub-screen will appear for
configuration:
Top Performance
******** DRAM Timing ********
DRAM Clock
DRAM Timing
DRAM BUS Selection
Primary Graphics Adapter
VLink 8X Supported
AGP Mode
AGP Read Synchronization
AGP Fast Write
Graphics Aperture Size
Top Performance
Allows you to enable/disable Top Performance function.
******** DRAM Timing ********
DRAM Clock
Allows you to set the SDRAM frequency.
Choices: By SPD; 200 MHz; 266 MHz; 333 MHz; 400 MHz
DRAM Timing
Allows you to select the DRAM Timing mode.
Choices:
Auto by SPD:BIOS will access SPD (Serial Presence Detect)automatically to configure
module timing;
Turbo;
Ultra;
Manual: If DRAM Timing is set to Manual, the following 8 items will appear for user's
configuration:
SDRAM CAS# Latency -- for SDRAM CAS#(Column Address Strode) Latency cycle:
1.5; 2.0; 2.5; 3.0
SDRAM Bank Interleave--allows you to enable / disable SDRAM Bank Interleave function:
Disabled; 2-way; 4-way
Precharge to Active(Trp)
2T; 3T; 4T; 5T
Active to Precharge(Tras):
6T; 7T; 8T; 9T;
Active to CMD(Trcd):
2T; 3T; 4T; 5T;
REF to ACT/REF to REF(Trfc):
12T; 13T; 14T; 15T;
ACT(0) to ACT(1) (Trrd):
2T; 3T;
DRAM Command Rate:
2T Command; 1T Command;
NorthBridge VIA KT880 Configuration
Disable
By SPD
Auto By SPD
Auto
AGP
Enabled
AGP 4X
Disabled
Disabled
64MB
70
Help Item