Table of Contents
Advertisement
5-2 To Enter VIA Tech. RAID BIOS Setup
Boot the KT880E-R/RL/GR system with "RAID Interface" enabled in
system BIOS Setup and watch for the following initial screen to appear:
VIA Technologies, Inc. VIA VT8237 Serial RAID BIOS Setting Utility
V2.10 Copyright (C) VIA Technologies, Inc. All right reserved.
Scan Devices, Please wait ....
Press < Tab > key into User Window!
Channel 0 Master: ST380023AS
Channel 1 Master: ST380023AS
(The above message indicates that the SATA hard disks on board are
detected by the RAID BIOS.)
As soon as the above screen appears, press < Tab > key to enter VIA
Tech. RAID BIOS Setup.
In a few seconds, the VIA Tech. RAID BIOS Setup Utility appears as
shown below:
Press <Enter> to create Array.
VIA Tech. VT8237 SATA RAID BIOS Ver 2.10
Create Array
Delete Array
Create/Delete
Spare
Select Boot Array
Serial Number View
Channel
Channel0 Master
Channel0 Slave
Channel1 Master
Channel1 Slave
Create A RAID array with the
hard disks attatched to VIA RAID
controller
F1
Enter : Confirm the selection
ESC : Exit
Drive Name
Array Name
ST380023AS
No Drive
ST380023AS
No Drive
The Hard Disks connected to
SATA connectors are detected by
RAID BIOS.
85
Chapter 5 SATA RAID
: View Array/disk Status
: Move to next item
Mode
Size(GB)
ATA 133
74.53
ATA 133
74.53
Status
Hdd
Hdd
Advertisement
Table of Contents
