Section 2: Edge Controller Operation; Introduction - Watts AERCO Benchmark BMK5000 Operation And Service Manual

Benchmark Platinum-Edge [ii]: Operation-Service Manual
SECTION 2: OPERATION

SECTION 2: EDGE CONTROLLER OPERATION

2.1 INTRODUCTION

This section provides a brief outline of how to gain access to Benchmark Boiler's Edge
Controller functionality. Full instructions for using the Edge Controller to setup, configure and
operate a Benchmark Boiler are included in the Edge Controller Manual.
NOTE: The Edge Controller Manual is document number OMM-0139, GF-213.
The Edge Controller is shown below. This panel contains all of the controls, indicators and
displays necessary to operate, adjust and troubleshoot the boiler.
The Edge Controller's front panel consists of a touchscreen display along with a variety of
indicators and buttons.
1
OMM-0137_J •
12/20/2022
2
3
4
5
6
7
8
9
10
11
Figure 2-1 Edge Controller Front Panel
Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST
Multi-Function Bar, shows either:
•
Fire Rate
1
•
Valve Position
Parameter Indicator for both temperature
read-outs:
•
2
LEFT: Inlet or Setpoint temperature
•
RIGHT: Outlet or System Header
temperature
Temperature scale indicator: Fahrenheit
3
or Celsius
Configurable temperature read-outs (2):
•
LEFT: Inlet or Setpoint
4
temperature
•
RIGHT: Outlet or System Header
temperature
Operation Mode Indicators (2):
•
LEFT: Demand or Manual
5
•
RIGHT: Manager or Client (BST
only)
6 Edge Controller Touchscreen
7 Soft Keys
8 onAER Indicator Light
9 Ready Light
10 Enable/Disable Switch
Low Water Level Buttons (2):
•
TEST: Initiates Low Water test
11
•
RESET: Resets unit after Low Water
test
Page 13 of 167