High Gas Pressure Test: Bmk3000 - 6000 Only - Watts AERCO Benchmark BMK5000 Operation And Service Manual

Benchmark Platinum-Edge [ii]: Operation-Service Manual
SECTION 5 – SAFETY DEVICE TESTING
HIGH Gas Pressure Test Instructions: BMK750 – 2500
HIGH GAS
BALL VALVE
MANUAL
SHUT-OFF
VALVE
Figure 5-3c: BMK2500: HIGH Gas Pressure Fault Test
5.3.2 HIGH GAS PRESSURE TEST: BMK3000 – 6000 Only
To simulate a high gas pressure fault, refer to Figure 5-4a and 5-4b and perform the following
steps:
HIGH Gas Pressure Test Instructions: BMK3000 – 6000 ONLY
1. Shut off the external gas supply by closing the external gas supply ball valve.
2. Locate the port on the side of the High Gas Pressure switch and loosen the screw in the
port a few turns to open it. Do not completely remove the screw. Alternatively, you can
remove the 1/4-inch plug shown in Figure 5-4a and 5-4b and install a hose barb fitting in
that location.
3. Attach one end of the plastic tubing to the port or barb fitting and the other end to a 0 – 16"
W.C. (0 – 4.0 kPa) manometer.
4. Apply the reading of the manifold pressure taken in Step 21 of Section 4.4.1 (natural gas
units) or Step 21 of Section 4.4.2 (propane units) and plug it into the following formula,
which calculates the maximum allowable gas pressure:
Natural Gas Pressure → ______ x 1.5 = ______ max gas pressure
BMK3000
BMK4000 &
Natural Gas Pressure → ______ x 1.5 = ______ max gas pressure
5000N
Natural Gas Pressure → ______ x 1.5 = ______ max gas pressure
BMK5000 &
6000
Propane Gas Pressure → ______ x 1.5 = ______ max gas pressure
5. Remove the cover from the High Gas Pressure switch and set the dial indicator to 20
(the maximum).
6. Open the external gas supply ball valve upstream of the unit.
OMM-0137_J •
12/20/2022
TO
AIR/FUEL
VALVE
Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST
SSOV
LOW GAS
PRESSURE
SWITCH
(P/N 22190 shown)
Page 67 of 167