Section 2. Edge [I] Controller Operation; Introduction - Watts Aerco Benchmark BMK750 Operation And Service Manual

Benchmark with Edge [I]: Operation-Maintenance Manual
SECTION 2: OPERATION

SECTION 2. EDGE [I] CONTROLLER OPERATION

2.1 INTRODUCTION

This section provides a brief outline of how to gain access to Benchmark Boiler's Edge [i]
Controller functionality. Full instructions for using the Edge [i] Controller to setup, configure and
operate a Benchmark Boiler are included in the Edge [i] Controller Manual, OMM-0141, GF-213-
B
The Edge [i] Controller is shown below. This panel contains all of the controls, indicators and
displays necessary to operate, adjust and troubleshoot the boiler.
The Edge [i] Controller's front panel consists of a touchscreen display along with a variety of
indicators and buttons.
1
OMM-0145_D • GF-218 •
11/2/2020
2
3
4
5
6
7
8
9
10
11
Figure 2-1 Edge [i] Controller Front Panel
Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST
Multi-Function Bar, shows either:
•
Fire Rate
1
•
Valve Position
Parameter Indicator for both temperature
read-outs:
•
2
LEFT: Inlet or Setpoint temperature
•
RIGHT: Outlet or System Header
temperature
Temperature scale indicator: Fahrenheit
3
or Celsius
Configurable temperature read-outs (2):
•
LEFT: Inlet or Setpoint
4
temperature
•
RIGHT: Outlet or System Header
temperature
Operation Mode Indicators (2):
•
LEFT: Demand or Manual
5
•
RIGHT: Manager or Client (BST
only)
6 Edge [i] Controller Touchscreen
7 Soft Keys
8 onAER Indicator Light
Ready Light
9
10 Enable/Disable Switch
Low Water Level Buttons (2):
•
TEST: Initiates Low Water test
11
•
RESET: Resets unit after Low Water
test
Page 13 of 213