Download Print this page

Eaf Assembly Instructions - Kasco F2400EAF Owner's Manual

50hz fountain, aerator, & circulator

Advertisement

15
STEP ONE
Remove all contents from package and place on a
clean, flat surface. Inspect the shipment for any dam-
ages. If damages are found, immediately notify your
carrier and your Kasco Marine, Inc. representative.
Next, cross reference the parts included in the ship-
ment with the Parts Included sheet in this manual on
page 13. Make sure you have all the parts needed. If
any shortages are found, contact your Kasco repre-
sentative immediately.
FOR F2400 & F3400 MODELS (SMALL FLOAT)
STEP TWO
Slide the two 50' Mooring Ropes around the Float
(Part B1) until they are opposite each other.
STEP THREE (retrofitting bottom screen)
If the retrofitting the optional Bottom Screen, it can
be installed now. Remove the Left bolt and nut from
each of the three mounting brackets on the float.
Turn float assembly upside down (brackets down)
and place large open end of screen on the float. Re-
place the three bolts previously removed with the 3
hooks provided with the Bottom Screen, making sure
the hook passes through the screen just inside the top
support ring of the screen (not through the
"handles"). Reattach the three Nuts removed on the
threaded end of the hooks.
STEP THREE
Support the Float at least 18" (46cm) above the
ground. Lower the Aerator into the Float making
sure the cord and cord retaining hook (A) fall

EAF ASSEMBLY INSTRUCTIONS

between mounting brackets on the float (B) and pref-
erable in line with one Mooring Rope. Make sure the
protective cage on the Aerator is fully seated in the
mounting brackets.
STEP FOUR
Use the Nylon Tie provided to tie the cord and Moor-
ing Rope together. This will help keep the cord free
of the propeller and help prevent damage. The Aera-
tor is now completely assembled and can be installed
following the instructions starting on page 17.
FOR 8400 MODELS (LARGE FLOAT)
STEP TWO
Arrange the three Float Sections (Part B2-1)upright
(plug on bottom) so the overlap on one section aligns
with the next section and loosely push the three sec-
tions together to form a continuous ring.

Advertisement

loading