8400EJF and 3.1EJF NOZZLE OPTIONS & PATTERN SIZES
NOTE: Pattern sizes listed are approximate. Variations in voltage caused by regional electrical differences or voltage drop
due to long power cords may result in reduced pattern sizes.
•
The Linden, Willow, and Juniper nozzles use the 3/8" x 4" bolt.
•
The Redwood nozzle must have the Y Insert installed prior to nozzle placement.
•
The Spruce nozzle must have the Insert removed prior to nozzle placement.
•
The Birch display does not require a nozzle.
•
The Sequoia nozzle uses the 2.5" bolt and only comes with the 3.1EJF.
REDWOOD
The Redwood
nozzle uses the 3
self tapping screws
to attach over the
pump housing and
the Y Insert must
be installed.
WILLOW
The Willow
nozzle (marked
W on the
inside of the
cone) uses the
3/8" x 4" bolt.
SPRUCE
The Spruce
nozzle uses the
three self tapping
screws to attach
over the pump
housing and the Y
Insert must be
removed.
Model
HP
Height
Width
8400EJF
2
5.5 m
1.5 m
3.1EJF
3
6.1 m
0.9 m
Model
HP
Height
8400EJF
2
3.4
3.1EJF
3
3.6
Model
HP
Height
8400EJF
2
5.5
3.1EJF
3
5.8
SEQUOIA
Model
3.1EJF
LINDEN
JUNIPER
The Juniper
nozzle (marked
with J on in
inside of the
nozzle cone)
uses the 3/8" x
4" bolt.
Width
10.4
8.2
BIRCH
The Birch display does not use a nozzle or bolt.
It is the fountain unit running without any
nozzle and allows for the best flow rate and
oxygen transfer!
Model
HP
Width
8400EJF
2
3
3.1EJF
3
2.1
The Sequoia nozzle
(marked S on the inside
of the cone) uses the 3/8"
x 2.5" bolt.
3.1EJF ONLY
HP
Height
Width
3
4.6
3.0
The Linden
nozzle (marked
L inside one of
the fins) uses the
3/8" x 4" bolt.
Model
HP Height
8400EJF
2
3.1EJF
3
Model
HP
8400EJF
2
3.1EJF
3
Height
Width
3.5
1.8
3.0
4.0
11
Width
4.7
10.4
4.1
9.8
Height
Width
1.8
13.4
2.7
12.2