Owners Manual 50Hz Fountains 4400EJ, 8400EJ, 3.1EJ 2.3E(H)J, 3.3E(H)J, 5.3E(H)J Contents Contents ..pg1 Important Safety Instructions ..pg2 General description of equipment and function ..pg2 Intended use and limits of use .
Installation, adjustment, maintenance, and removal of this equipment should be limited to experienced maintenance persons or trained professionals. If you are not sure how to install or operate any Kasco products call your local distributor, contact an electrician, or contact Kasco customer service at www.kascomarine.com for further assistance.
The instructions provide detailed warnings and instructions for such activities and should only be performed by a trained person. Unit Specs Model Voltage Operating lock rotor range amps amps 4400EJ 208-240 6.5@220V 20@220V 8400EJ 208-240 9.5@220V 40@220V 3.1EJ 208-240 13.2@220V 60@220V...
Quick Disconnect Installation Important – Read Carefully Before Installation Before using the connector, it is important that these instructions are carefully read and understood to ensure the connector system is completely water tight and electrically safe. IF IN DOUBT CONSULT A QUALIFIED ELECTRICIAN. The socket (female) insert of the connector must be the live part of the connector from the supply.
Page 5
The Strain Relief must be installed to protect the Quick Disconnect from damage due to excessive strain. The Strain Relief should be installed on the user supplied cord length (not on the Kasco sup- plied stub cord). It should be position about 15cm from the Quick Disconnect. To install, insert the narrow end of the elongated clamp with the chain connected into the wide end of the short clamp.
The chart below shows the proper Gland to be used with different cord sizes. The measurements are based on the Outside Diameter (O.D.) of the cord. Smooth, round cords should be used. (HAR H07RN-F) Kasco Quick Disconnect 50 Hz Size Chart: Gland O.D.
You must verify motor rotation before installing the unit in the water. 3phase Kasco units will run in a clockwise rotation when looking down at the propeller/impeller. On J series units the upper pump housing must be removed to see the propeller/impeller. Stand clear of the propeller/impeller while verifying rotation. Follow the steps below.
The weight should be light enough so the Unit can rise as the water level rises. This can also help hide ropes by sinking them further below the surface. Normal Water level Low Water Level Kasco Power Control Box Anchor Rope Power Cord...
Even though Kasco Fountains are among the most clog-resistant on the market, it is impossible to protect against all items that can clog equipment and still maintain a flow of water.
Troubleshooting Tips Troubleshooting tips The following is provided to help diagnose a probable source of trouble. It is a guideline only and may not show all causes for all problems. For additional troubleshooting help contact your local distributor or visit www.kascomarine.com for additional tips Problem Possible Cause Likely Remedy...