Advertisement
19
STEP SEVEN
Insert the Spacer Bracket (Part B7)under the U-
Bracket and inside the cage. Secure this assembly
using one 1/4" x 1" Bolt (Part B9) and a 1/4" Lock
Nut (Part B11), and one 1/4" x 1-1/4" Bolt (Part B10)
and a 1/4" Hex Nut (Part B12). The longer bolt
should be on the side of the U-Bracket that is closer
to the cord clamp. Tighten the hardware using the
7/16" (11mm) wrench and socket & wrench until the
U-Bracket clamps firmly around the cage (U-Bracket
should pull together slightly). Repeat with the second
U-Bracket.
STEP EIGHT
Attach an Angle Bracket to each of the longer (1-
1/4") bolts on the U-Brackets (See photo for orienta-
tion) with a 1/4" Lock Nut.
Models 2400 & 3400
STEP NINE
Wrap the Draw Band (Part B5) around the motor
housing and position so that the back of the Draw
Band touches the marks drawn in Step Five. There is
no front or back to the Draw Band itself - it is reversi-
ble. Orient the arm of the Draw Band so it aligns
with the cord clamp on the cage of the motor housing
and is parallel to the Angle Brackets attached in Step
Eight. Secure using a 1/4" x 1" Stainless Steel Bolt
and a 1/4" Lock Nut. (See photo in next column)
STEP TEN
Attach the Angle Bracket on the motor to the Angle
Bracket on the Float using two 1/4" x 1/2" Bolts and
two 1/4" Lock Nuts (one set for each Bracket). See
photos for orientation based on model size. Also, the
cord clamp on the cage should be oriented toward the
Float.
Model 8400
STEP ELEVEN
Attach the Draw Band on the motor to the Adjust-
ment Bracket on the Float using a 1/4" x 1/2" Bolt
and a 1/4" Lock Nut. Select one of the five possible
positions to mount the Draw Band for your preferred
direction of flow (three are pictured on next page).
We do not recommend the two outer (most upward
and most downward) mounting positions for 8400
models.
Models 2400 & 3400
Step Nine
Model 8400
Advertisement
