• Kasco Aerating Fountains are intended for use with a Listed control panel having a GFCI protected re- ceptacle, or field wiring terminals and disconnect switch, or a timer with a disconnect for use with a GFCI receptacle.
Use & Operation Kasco fountains are designed and engineered for continuous duty, such as on fish farms or other aquacul- ture applications, or on-demand use, as needed in a recreational water feature. During flotation operation, the water is pulled from 360 degrees around the unit and from below the unit.
C-25 plug in Plug into C-25 4400HJF 208-240 Hardwire C-85 Plug into or hardwire C-85 Cord Gauge 50 ft. 100 ft. 150 ft. 200 ft. 250 - 400 ft. 3400JF 3400HJF / 4400HJF 4400JF 3400 - 4400 J SERIES FOUNTAIN MANUAL...
Page 7
4. Tighten down in 6 places to hold the screen together. 5. Secure the bottom screen to the float in 3 places. Make sure cord is sticking out of notch. 3400 - 4400 J SERIES FOUNTAIN MANUAL...
Page 8
If your Kasco cord comes with a strain relief kit at- tached, attach the available link to the float-side knot in the mooring rope, as pictured here.
Pattern sizes listed are approximate. Variations in voltage caused by regional electrical differences or voltage drop due to long power cords may result in reduced pattern sizes. To install, place o-ring around outlet and simply twist the nozzle into the 3 locking tabs. 3400 - 4400 J SERIES FOUNTAIN MANUAL...
Low water level High water level After unit is installed in the water, connect the power cord to a properly installed Kasco control panel (C-85, C-95, etc.) with built-in ground fault protection according to the instructions and electrical schematics in- cluded with the panel.
(at least every two to three months). Seal replacement and all other repair services should be performed by Kasco Marine or a Kasco-trained Au- thorized Repair Center. Any alterations or changes made to Kasco units by an unauthorized source will void the warranty.
“My fountain turns itself off and back on without the timer and without tripping the GFCI breaker.” (single phase units only) Each Kasco fountain has a Thermal Overload built in that will turn the unit off when it overheats. Once the unit has cooled down, it will start back up.
Please ship according to the instructions on the previous provided. Kasco Marine does estimates on repairs at the request of the customer. The request for estimate should be included in the letter that accompanies the returned unit and must include a daytime phone number and/ or e-mail address.
Back to Contents REPAIR CONTACT FORM • Kasco requires that all equipment sent for repair MUST be accompanied by this form and marked to Repairs attention. Kasco Marine • Unit should be cleaned before shipping. 800 Deere Road • Kasco is NOT responsible for shipping damage accrued in Prescott, WI 54021 return shipment.