Assembly Instructions - Kasco J Series Operation & Maintenance Manual

ASSEMBLY INSTRUCTIONS

1� Place the float (D) over the unit assembly (G). Ensure the three channels on the inside of the float line up with the threaded holes
in the baseplate, and the Kasco logo on the top side of the float lines up with the power cord on the unit assembly. This will allow
the power cord to run in the power cord channel on the underside of the float later.
Fig. 5-7
2� Using the 9/16'' side of the wrench tool (J) or a socket wrench, secure the float to the unit assembly using the 3/8 - 16 x 3'' hex
head screw (A), 3/8'' lock washer (B), and 3/8 x 1�25'' fender washer (C), threading into the holes in the baseplate� Repeat for all
three holes�
Fig. 8-9
2 – 3 HP J SERIES FOUNTAIN
7
Dedicated power
cord channel
Back to Contents
MANUAL
884168 / 2021.1.1