Advertisement
12
8400EJF & 3.1EJF ASSEMBLY AND INSTALLATION INSTRUCTIONS
STEP ONE
Remove all contents from package and place on a
clean, flat surface. Inspect the shipment for any dam-
ages. If damages are found, immediately notify your
carrier and your Kasco Marine, Inc. representative.
Next, cross reference the parts included in the ship-
ment with the Parts Included sheet in this manual on
page 9. Make sure you have all the parts needed. If
any shortages are found, contact your Kasco repre-
sentative immediately.
STEP TWO
Arrange the three Float Sections (Part B1) upright
(plug on bottom) so the overlap of one section aligns
with the next section and loosely push the three sec-
tions together to form a continuous ring.
STEP THREE
Position one Top Float Bracket (Part B2) so that the
bolt holes in the bracket align with the bolt holes in
the two adjoined float sections and insert two 9"
Black Coated Bolts (Part B4) through the assembly.
This may require some minor repositioning of the
float sections as you push the bolt all the way
through. Do not force the bolt through. Repeat for
the remaining two joints.
STEP FOUR
Turn the assembly upside down and place the Bottom
Float Brackets (Part B3) over the bolts, the ends of
which should now be extending through the assem-
bly. Loosely install the six Lock Nuts (Part B5) on
the ends of the bolts (do not tighten yet). Connect the
top and bottom brackets using three 1/4" x 3/4" Bolts
(Part B7) with
the three 1/4"
Lock Washers
(Part B8) and
1/4" Nuts (Part
B12) and tighten
using the
7/16" (11mm)
wrench and
socket.
STEP FIVE
Stand the assembly on its side and center the Top
Screen (Part B10) inside the three Top Float Brack-
ets. Attach the screen by spanning each Top Screen
Clip (Part B11) across the two innermost rings on the
screen and the hole
in the float
bracket. Insert the
Brass Screws (Part
B14) and attach
with 1/4" Lock
Washers and 1/4"
Nuts to secure the
screen to the float
assembly.
STEP SIX
Return the assembly to the upside down position and
place the motor assembly (Stainless Steel can side up,
black pump down) in the center of the float. Attach
the motor to the float using the Unit Mounting Brack-
ets (Part B6). The notch in the center of the Unit
Mounting Brackets should be positioned over the top
ring of the cage and should be attached to the float
bracket using the two middle holes of the float
bracket. Tighten using the 1/4" x 3/4" Bolts with
1/4" Lock Washers using the 7/16" socket and
wrench. (See pictures on next page) Note: If you
have trouble positioning the Unit Mounting Bracket
between the Cage and Fountain Housing, you can
use a screwdriver to gently pry open enough space.
Advertisement
