Table of Contents
Advertisement
Specifications
AC input specifications
Based on the system requirements, each power module contains one power supply unit (PSU).
Input
Power maximum
Input voltage
Input frequency
Inrush current
Efficiency
Efficiency standard
Dimensions
The J2000 is designed for installation into a standard 2U 48.3 cm (19 in) rack that complies with the EIA-310-D
specification.
Item
Chassis length: Front vertical rail to chassis rear
Overall length: Front outside edge of bezel stud to outside
edge of cable management arm (CMA) baskets
Chassis depth: Front surface to canister handle
Serviceable position pull length for fan access
Rack post depth
Rack envelope
J2000 width with rack ears
Height
Power module specifications
The J2000 is powered by two high-efficiency, hot-swappable power modules installed in the right and left power cavities
on the rear panel. By default, each power module includes one factory-installed 1600 W PSU and one factory-installed
power adapter board. Replacing a PSU requires replacement of the entire power module. The PSU and power adapter
board cannot be replaced as separate components.
Each power module has active current sharing and supports 1+1 redundancy. A single power module can power the
J2000 indefinitely; however, both power modules are required to ensure redundancy. The power module provides 12 V
power and 3.3 V standby power to the system and includes an internal cooling fan (not field serviceable).
Shock and vibration specifications
Shock and vibration levels are tested in a simulated rack condition.
PSU
1600 W
200–240 V AC
50–60 Hz
35 A peak
91% at 100% load
80PLUS Platinum
Measurement
67.6 cm (26.6 in)
96.3 cm (37.9 in)
72.2 cm (28.4 in)
17.8 cm (7.0 in)
68.2 cm (27.0 in) to 94.0 cm (37.0 in)
1.0 cm (39.4 in)
49.2 cm (19.4 in)
8.7 cm (3.4 in)
Features and specifications
33
Advertisement
Table of Contents
