Table of Contents
Advertisement
NOTE: Verify the appropriate COM port for use with the J2000 serial CLI. This is determined by your server or laptop
configuration.
The I/O module IP address is displayed on the serial console in the Manager IP Address field. If the IP address is not
initially displayed, press Enter until it appears in the CLI window.
Manager FW version : J2000-MGR-02.01.16-DEV-CS-01
Manager IP Address : 10.10.10.101
Chassis Serial Number : US0000P000
Peer is : Active
2. Open a web browser, and in the address bar, enter the I/O module IP address.
https://<I/O-Module-IP-Address>
The Login window is displayed.
3. Enter the Administrator user name (default is Admin) and password (default is the system serial number which is
located on the front right ear of the enclosure), and then click Login.
Changing the Administrator password
Procedure
1. After logging in to the WebUI for the first time, select the Admin drop-down menu in the upper-right area, and then
select Admin Dashboard.
2. On the USERS tab, locate and select the Admin user in the list, and then click the Edit icon (green pencil) under
Actions.
3. In the User Details pane, enter a new password, and then click Save.
Verifying I/O module status and settings
Procedure
1. Click on the IOMS tab in the WebUI. The 2 IOMs are shown as sub tabs.
2. View or edit the I/O module settings by clicking IOM x.
The I/O module state and details are displayed.
3. Click Settings to open the selected IOM's settings page, and then click Edit to configure the I/O module.
The ability to edit some items depends on whether DHCP is enabled or disabled.
•
DHCP is enabled by default and the network information is obtained automatically when the system is powered on.
If the information is correct, no changes are necessary.
•
To edit the network information, disable DHCP (toggle DHCP to the left, OFF). The network information fields
become available.
4. Click Save.
19
Configuration
Advertisement
Table of Contents
