Table of Contents
Advertisement
Configuration
WebUI for system setup
The J2000 includes a WebUI that enables system administrators to manage the enclosure and map hosts to NVMe drive
namespaces.
Logging in to the WebUI
NOTE: The administrator user name and password fields are case-sensitive.
Procedure
1. Identify or set the I/O module IP address.
•
If the network management ports are connected and DHCP is enabled on your network, obtain the DHCP-assigned
IP address by looking in the DHCP server pool of leased addresses for the two MAC addresses assigned to the
HPE J2000 NVMe-OF IO Modules.
•
If you cannot connect to the I/O modules through your network, obtain the network port IP addresses manually by
using the provided CLI USB cable to connect one of the I/O modules to a USB port on a host computer. Use a
supported terminal emulator application such as PuTTY with the following display and connection settings:
Table 1: Terminal emulator display settings
Parameter
Terminal emulator mode
Font
Translations
Columns
Table 2: Terminal emulator connection settings
Parameter
Connector
Baud rate
Data bits
Parity
Stop bits
Flow control
Value
VT-100 or ANSI (for color support)
Terminal
None
80
Value
COM3 (for example)
115,200
8
None
1
None
18
Configuration
Advertisement
Table of Contents
