Table of Contents
Advertisement
Installing the rail kit inner rails onto the chassis
Procedure
1. Align the large section of the keyholes on the right inner chassis member rail with the standoffs on the right side of the
chassis.
NOTE: Right and left are marked on the front of the adjustable rack mounting rails to indicate proper placement. The
shelves on the bottom of the left and right rails must be positioned towards the inside of the rack.
2. To secure the standoff on the smaller section of the keyhole to lock the rail into place, slide the rail towards the back of
the J2000 until it will not slide any further.
1
3. Secure the rail using one of the M4 X 4 screws in the hole behind the rail kit release tab.
4. Repeat the preceding steps to secure the left inner chassis member rail onto the chassis.
Installing the rail kit outer rails onto the rack posts
Procedure
1. Insert the alignment pins into the front rack post at the correct U position.
2. Verify that the latch is seated and the outer rail member is secure to the rack.
3. Press and hold the release catch for the rear outer rack member.
4. Insert the rear alignment pins into the correct U position of the rack rear post.
5. Release the release catch and verify that the catch is seated and secure to the rear rack post.
2
1
10
Installation
Advertisement
Table of Contents
