HPE J2000 Flash Installing And Configuring page 15

Procedure
1. Verify the direction for each CMA.
2. To change the direction of the CMA for use on the opposite side of the J2000, press the CMA release button and spin
the CMA 180°.
3. Connect all peripheral cables and power cords to the rear panel.
a. Slide the inner CMA arm connector onto the right inner rail connector (1).
b. Slide the outer CMA arm connector into the right outer rail connector (2).
c. Slide the CMA body connector onto the left CMA outer rail connector (3).
4. Open the cable clamps.
1
3
2
Installation
15