Table of Contents
Advertisement
Procedure
1. Align the ends of the bezel with the right and left J2000 ears.
2. Push the bezel retention clip onto the ball studs on the left and right J2000 ears.
Powering on the system
The J2000 powers on the solid state drives in an ordered sequence to avoid drawing a large amount of power during
system startup.
Procedure
1. Plug a power cable into each of the J2000 power supplies.
2. Plug the power cords into an active power distribution unit (PDU).
System power is initiated when the first power module is plugged into the PDU.
3. System is fully powered and ready to be managed after 2 minutes.
17
Installation
Advertisement
Table of Contents
