Table of Contents
Advertisement
8.2.9.9
SYSTem:TIME:DAYLight? [MIN|MAX|DEF]
Returns the automatic daylight saving adjustment setting.
Example: SYST:TIME:DAYL?
Response: 1
A value of 0 is returned if the daylight saving adjustment is disabled. A value
of 1 is returned if the daylight saving adjustment is set to North America (N
AMER). A value of 2 is returned if the daylight saving adjustment is set to Eu-
rope (EUROPE). Specifying the MIN, MAX, or DEF parameter returns the
minimum, maximum, or default value respectively.
8.2.9.10
SYSTem:TIME:DAYLight <num>|MIN|MAX|DEF
Sets the automatic daylight saving adjustment setting.
Example: SYST:TIME:DAYL 1
The <num> parameter sets the automatic daylight saving adjustment setting to
off (0), North America (1), or Europe (2). This command may be password
protected (see Section 8.2.10, Password Commands).
8.2.9.11
SYSTem:TIME:FORMat? [MIN|MAX|DEF]
Returns the time format used for the display.
Example: SYST:TIME:FORM?
Response: 1
A value of 0 is returned if the time format is set to 12 hour. A value of 1 is re-
turned if the time format is set to 24 hour. Specifying the MIN, MAX, or DEF
parameter returns the minimum, maximum, or default value respectively.
8.2.9.12
SYSTem:TIME:FORMat <num>|MIN|MAX|DEF
Sets the time format.
Example: SYST:TIME:FORM 0
The <num> parameter can be 0 (12 HR) or 1 (24 HR). Specifying the MIN,
MAX or DEF parameter sets the time format to the minimum, maximum, or
default value respectively. This command may be password protected (see Sec-
tion 8.2.10, Password Commands).
8.2.10
Password Commands
The password commands are used for enabling and disabling the password-pro-
tected commands, for querying and setting the password-protected state, and
for setting a new password. These commands are always password protected.
8 Digital Communications Interface
Commands
117
Advertisement
Table of Contents
