Table of Contents
Advertisement
1620A "DewK" Thermo-hygrometer
User's Guide
8.2.11.17
8.2.11.18
128
Status Bit of the Status Byte Register. If any bit in the Measure Status Event
Register is set (1) while its corresponding mask bit in the Measure Status En-
able Register is set, the Measure Status Bit in the Status Byte Register will be
set. The value of the <num> parameter is a number from 0 to 15 that is the sum
of the binary-weighted values of each mask bit. The Measure Status Event Reg-
ister is described in Section 8.4.11.13, STATus:MEASure?. The following ex-
ample causes the Measure Status Bit in the Status Byte Register to be set when
measurements on both channels have been completed.
Example: STAT:MEAS:ENAB 15
Response: 15
STATus:OPERation?
This command reads and clears the Operation Status Event Register. The value
returned indicates the condition of each of the eight bits of the register by add-
ing the binary-weighted values of each bit. The meaning of each bit, when set
(1), is as follows where 0 is the least significant and 7 is the most significant:
0:
no measurement
Bit 0
Not used.
Bit 1
Not used.
Bit 2
Not used.
Bit 3
Not used.
Bit 4
Measurement Complete bit.
Bit 5
Not used.
Bit 6
Not used.
Bit 7
Not used.
Example: STAT:OPER?
Response: 16
STATus:OPERation:CONDition?
This command reads the Operation Status Condition Register. Reading this reg-
ister does not affect it. The value returned indicates the condition of each of the
eight bits of the register by adding the binary-weighted values of each bit. The
meaning of each bit, when set (1), is as follows where 0 is the least significant
and 7 is the most significant:
0:
no operation
Bit 0
Not used.
Bit 1
Not used.
Advertisement
Table of Contents
