Chapter 2 SMART TEST function
Performing acquisitions in Smart TEST mode
•
If you click on N
•
If you click on Y
NOTE
If the measurement is validated despite the traffic (key Yes), the next mea-
surement will be automatically performed, even if traffic is still detected on
fiber.
If the measurement is canceled (key N
time, the box asking if you wish to continue or not is displayed.
The functioning of Traffic Detection is then indicated in the scaled down
representation of trace, on the upper left part of screen: LFD is flashing.
During an acquisition in real time, several actions can be made on results in progress:
see
"Actions on trace during acquisition" page
Once results is
Stopping the real time acquisition
To stop or interrupt an acquisition in real time mode, press the Start key at any time.
Performing an acquisition in Smart TEST mode
1
From the Setup page, press Start Test key
Figure 7 on page
The red Testing indicator goes on to show that the T-BERD/MTS is in process of
acquisition and the screen displays the trace in process of acquisition.
2
The quality of the connection is displayed for a
few seconds (see
3
Then, a bar graph shows elapsed and remaining acquisition time.
14
, the measurement is not launched.
O
, the measurement is performed, despite the traffic.
ES
10).
Table 1 on page
User Manual
), and the Start pushed another
O
15.
13)
700MAN201 Rev. 004
to launch measurement (see