Advertisement
Wire Ties
Wire Cutter
N
*Connect the disarm / programming button to the corresponding remote start module connector (if disconnected).
O
*Route the disarm / programming button along the remote start harness, toward the remote start module.
T
*Secure the disarm / programming button and the remote start harness with (1) large wire tie, as shown above.
E
*Secure the remote start harness and the disarm / programming button to the factory wire harness with (1) large wire tie, as shown
above.
*Secure the remote start harness to the factory wire harness connected to the fuse panel with (2) large wire ties, as shown above.
*Trim off excess wire ties.
*Ensure disarm / programming button is secured to the remote start harness in a manner that allows for future serviceability.
WARNING! Engine Stall Hazard.
!
column is fully extended, if equipped. Ensure all connectors are fully engaged and locked in place.
cause serious physical injury or vehicle damage.
WARNING! Shock Hazard. Do not touch vehicle's negative battery terminal to vehicle's positive battery terminal.
!
Serious physical injury or vehicle damage may occur.
HYUNDAI Genuine Accessories (Installation)
To prevent stress on the remote start wire harness, ensure the tilt/telescopic steering
Negative Battery Cable
Revision Date
Fuse Panel
Wire Ties
1/4" Drive Ratchet, 10 mm Socket
N
*Verify all connections are secure as per the installation
O
instructions.
T
*Turn the ignition key to the ON position.
E
*Reconnect the negative battery cable. If the horn be-
gins sounding, press the disarm / programming button
with the ignition "ON" to disarm the system.
*Start the vehicle and verify that no air bag or engine
codes have been triggered. Any fault codes should be
addressed before proceeding to the next step.
*Turn the ignition key to the OFF/LOCK position.
5/2/2012
Dash Wall
Grommet
15
An engine stall could
16
Page 18 of 29
Advertisement
