Advertisement
1/4" Drive Ratchet, 10 mm Socket, 1/4" Drive Torque Wrench, Wire Cutter
*Locate the factory GE07, 10 mm ground bolt in the driver's kick panel area, near the vehicle dash wall.
N
*Route the Black (Ground) wire with ring terminal behind the factory wire harness to the GE07 factory ground location.
O
T
*Remove the 10 mm bolt. Position the Black (Ground) wire with ring terminal over the bolt and reinstall with the factory ground wire.
*Torque to 15 lb-ft (21 Nm).
E
*Route the Yellow (Dome Light Output) along the factory harness, up to the driver's "A" pillar area.
*Secure the Yellow (Dome Light Output) wire to the vehicle wire harness with (1) small wire tie, as shown above. Trim off excess
wire tie.
HYUNDAI Genuine Accessories (Installation)
Wire Tie
Yellow Wire
(Dome Light Output)
Revision Date
GE07 Factory Ground
5/2/2012
13
Page 16 of 29
Advertisement
