Advertisement
HYUNDAI Genuine Accessories (Transmitter Programming Procedure)
N
* Open the driver's door.
O
T
E
N
* Locate the disarm / programming button.
O
T
E
Note: The disarm / programming button is secured to the
remote start wire harness, located behind the lower
dash finish panel.
1X
N
*Press the Panic button one time, the horn will beep one
O
time indicating that the transmitter code has been learned.
T
*Repeat this process for each additional transmitter.
E
HYUNDAI Genuine Accessories (Transmitter Battery Test Procedure)
N
*Open/separate the transmitter case using a coin at the bot-
O
tom.
T
*Remove the (2) batteries from the transmitter.
E
*Using a DMM, check the voltage on each battery.
*If the voltage is less than 3 volts on either battery, replace
the depleted battery with (P/N: CR2016).
Note: It may not be necessary to replace both batteries.
1
3
X1
5
1
Recycle or dispose of the old batteries according
to your local laws or regulations.
Revision Date
5/2/2012
N
*Turn the vehicle ignition to the "ON" position; do not start
O
the engine.
T
E
N
*Press and hold the disarm / programming button for 10-15
O
seconds, the horn will beep 3 times.
T
*Release the disarm / programming button.
E
N
* Turn OFF vehicle ignition.
O
T
E
Insert Coin Here To Separate
2
X3
4
6
The (+) sign
must face
upward on
both
batteries.
Page 27 of 29
Advertisement
