Advertisement
Ensure the transportation fuse is properly installed before performing the function check.
If the transmitters fail to operate, refer to Page 26 (Transmitter Programming and Battery Test Procedure).
Items To Be Checked
Remote Engine Start - Make sure the key is removed
from the ignition switch and the engine hood and trunk
are closed. Activate the remote engine start by pressing
lock followed by start within 3 seconds.
Brake Pedal Safety - Press unlock and enter the
vehicle. Press the brake pedal.
Key-In-Sense - Insert the ignition key into the ignition
switch but keep it in the OFF position. Activate the
remote engine start using the transmitter.
Hood Safety Switch - Remove the key from the
ignition and activate the remote engine start. After the
vehicle has started, press the unlock button on the
transmitter to disarm the security system and pull the
hood release lever to release the hood. Open the door
and exit the vehicle.
Door Lock - Close the engine hood and all doors and
press the lock button on the transmitter.
Door Lock - Press the lock button on the transmitter a
second time within 5 seconds.
Door Unlock / Headlight Welcome Feature - Press the
unlock button on the transmitter.
Door Unlock / Headlight Welcome Feature - Press the
unlock button on the transmitter a second time within 5
seconds of unlocking the driver's door.
Trunk Release - Press and hold the trunk release button
on the transmitter for 3 seconds to activate.
HYUNDAI Genuine Accessories (Function Check)
Results Of The Check
The parking lights will flash one time, the horn will beep once,
then the vehicle will crank and start. Once started, the horn will
beep once again and the parking lights will turn on and stay on
signifying the engine is running.
The engine/remote start will turn off.
The parking lights will flash once and the ignition will turn on as
if it is going to start. But, the horn will beep twice and the
remote engine start will not attempt to start the vehicle since it
detects the key in the ignition. In addition, the driver's door will
unlock and the vehicle's interior light will illuminate and quickly
fades off.
NOTE: Interior lamp switch must be set to the door position to
illuminate.
The engine/remote start will turn off immediately.
The hood should not have to be lifted to activate the hood safety
switch.
The parking lights will flash one time to indicate that the vehicle
is armed and locked.
The parking lights will flash one time and the horn will beep one
time giving audible confirmation that the vehicle is locked and
armed.
The parking lights will flash two times to indicate that the
vehicle is disarmed, the headlights will turn on for 15 seconds
and unlock the driver's door only.
NOTE: If all doors unlock with the first press of the unlock
button on the transmitter, check the unlock operation of the
factory transmitter. To enable priority unlock, press the lock and
unlock buttons on the factory transmitter simultaneously for 5
seconds or more. The hazard lights will flash 4 times to confirm
the unlock mode has been changed.
The parking lights will flash two times to indicate that the vehicle
is disarmed, the headlights will turn on for 15 seconds and unlock
all remaining doors.
The trunk will open.
Revision Date
5/2/2012
Page 19 of 29
Advertisement
