Advertisement
Vehicle Preparation
*Clean hands.
*Set the parking brake and open driver's door window.
*Record radio station presets, if applicable.
*Vehicle should be at room temperature.
*Ensure vehicle is equipped with automatic transmission, power door locks and power windows. If the vehicle is not equipped
with these options, do not proceed. Ensure vehicle does NOT have SMART KEY.
*ENSURE THE TILT/TELESCOPIC STEERING WHEEL COLUMN IS FULLY EXTENDED AND LOCKED BEFORE
INSTALLING THIS ACCESSORY.
Warning
Label
1/4" Drive Ratchet, 10 mm Socket
*Remove and isolate the negative battery cable from the
N
battery.
O
*Using alcohol, clean the top surface of the air filter box
T
assembly.
E
*Remove the backing on the underhood label and mount in
place, as shown above.
WARNING! Shock Hazard. Do not touch vehicle's
!
negative battery terminal to vehicle's positive battery
terminal. Serious physical injury or vehicle damage
may occur.
Push Clip
Pressure
Clip
Trim Tool, Phillips Screwdriver (if applicable)
N
*Carefully pull the weatherstrip away from the side of the
O
driver's side kick panel.
T
*Remove the hood release lever by removing the (1) phillips
E
screw (if equipped) and pulling toward the center of the
vehicle.
*Remove the driver's side kick panel from the vehicle by
pulling backward to release the upper push clip and out-
ward to release the (1) pressure clip.
HYUNDAI Genuine Accessories (Vehicle Disassembly)
Negative Battery Cable
Phillips Screw
(If Equipped)
Hood
Release
Lever
Pressure Clips x 3 (Sedan Models)
1
Pressure Clips x 5 (Coupe Models)
Retaining Tab
(Coupe Models)
Trim Tool
*Remove the driver's side front door step sill trim by insert-
N
ing the trim removal tool under the trim panel and prying
O
T
upward to release the (3) pressure clips (Sedan Models) or
E
(5) pressure clips and (2) retaining tabs (Coupe Models).
Pressure
Clips
3
Trim Tool
N
*Disassembly Tip - Remove the fuse panel access cover
O
to assist in the removal of the driver's side dash end cap.
T
E
*Remove the driver's side dash end cap panel by prying
outward to disengage the (4) pressure clips.
Revision Date
5/2/2012
0
Retaining Tab
(Coupe Models)
2
Fuse Panel
Access
Cover
Pressure
Clips
4
Page 4 of 29
Advertisement
