Advertisement
Pressure Clip
Weatherstrip
Pressure Clip
Wire Cutter
N
*Carefully pull the weatherstrip away from the driver's side "A" pillar.
O
*Starting at the top, partially remove the driver's side "A" pillar trim panel by carefully pulling inward to release
T
the (1) Tether Clip and the (2) Pressure Clips.
E
*With the "A" pillar trim panel partially pulled away from the body structure, reach behind the trim panel and cut
the tether clip, as shown above.
*Remove the "A" pillar trim panel from the vehicle.
CAUTION! Do not cut anything other than the "A" pillar tether clip.
Do not lose the (2) plastic pressure clips or damage any airbag components.
Pliers
N
*Using pliers, pull the remaining portion of the tether clip from the "A" pillar body structure.
O
*Remove the portion of the tether clip that is in the "A" pillar trim panel by twisting counterclockwise 90° and
T
pulling outward. Discard both portions of the tether clip, as shown above.
E
CAUTION! Do not scratch or damage "A" pillar trim panel.
HYUNDAI Genuine Accessories (Vehicle Disassembly)
Tether Clip
Revision Date
5/2/2012
Cut Here
Twist Counterclockwise
Pressure Clip
9
10
Page 7 of 29
Advertisement
