Advertisement
Pressure Clip
Weatherstrip
N
*Install (1) Tether Clip, in the closed position, into the "A" pillar trim panel. Rotate clockwise until it locks into place.
O
*Reinstall the driver's side "A" pillar trim panel by carefully engaging the (1) Tether Clip and the (2) Pressure Clips.
T
*Reinstall the weatherstrip near the driver's side "A" pillar.
E
CAUTION! Do not lose the plastic pressure clips or damage any airbag components.
Phillips Screwdriver
N
*Reinstall the lower steering column shroud around the steer-
O
ing column.
T
*Reinstall the (3) phillips screws securing the steering col-
E
umn shroud (1 underneath and 2 behind the steering wheel).
Turn the steering wheel for access, as shown above.
**NOTE: To access screws, insert key and turn to the ACC
position, in order to prevent the steering wheel from
locking.
Use care when securing the steering column shroud to
avoid misalignment, which could cause unwanted noises
when turning the steering wheel.
HYUNDAI Genuine Accessories (Vehicle Reassembly)
Pressure Clip
Phillips
Screws
Tether Clip
10 mm Nuts
10 mm Bolt
2
1/4" Drive Ratchet, 10 mm Socket
N
*Reinstall the (2) 10 mm nuts and (1) 10 mm bolt securing the
O
fuse panel to the metal dash brace.
T
E
CAUTION! Use care when securing the fuse panel to
avoid pinching the wire harness.
Revision Date
5/2/2012
1
3
Page 21 of 29
Advertisement
